Overflow Processing Parts x5 Set + Hole Saw Medaka Breeding Case Tub Tro-bune

↓↓ Products from Goshiki Aqua
#Goshiki Aqua Listings
#Sets with different quantities or with/without hole saw

A set of parts for overflow processing and a drilling tool to maintain a constant water level in breeding tanks for medaka and goldfish during heavy rain or when adding water.

Ideal for preventing overflow in synthetic resin medaka breeding containers such as NV boxes, jumbo basins, and tro-buns.
Comes with easy-to-understand instructions with many illustrations, so even beginners can use it with confidence.

The cap can be easily removed by hand for easy maintenance of dirt and clogs.
The mesh hole diameter is approximately 2.5mm (※Newly hatched fry may pass through the holes).

Includes gaskets, so no waterproofing is required, and it can be easily disassembled after installation, making it convenient for storing the container.

[Set Contents]
* L-shaped pipe, straight pipe, 2 rubber gaskets, plastic plated cap x Quantity listed in product name, Installation instructions
* 22mm hole saw for electric drill x 1 (※Not compatible with impact drivers with hex shank)

★Standard color is deep indigo, but gray is also available. If you wish for gray, please contact us after purchase stating Gray desired (combination of deep indigo and gray is also OK).
If no specification is made, deep indigo will be shipped.★

High-quality hole saws are surprisingly expensive, but the hole saw included in this set is an inexpensive Chinese product. However, it has sufficient accuracy for drilling holes in resin containers and shows no signs of deterioration even after about a thousand uses.

[Installation Procedure]
1. Determine the drilling position and make a pilot hole with a pointed tool such as an awl.
2. Drill the hole with the hole saw and smooth out any burrs or rough edges to some extent with a file or cutter.
3. Sandwich the gasket on the inside (or both inside and outside) of the container, pass the L-shaped and straight pipes through, and tighten by hand (light tightening by hand is sufficient).

※If the drilling position is set too high, you can adjust the water level by tilting the pipe downwards. However, you cannot adjust it upwards, so a higher position is recommended.

[Notes]
?Containers shown in the photos are not included in the product.
?Color and texture may vary slightly depending on the lot. In particular, the gray type may have a significant difference in color between the inner and outer parts.
?There are no barcode stickers that are troublesome to peel off.